Proscan PS60690 60" Rear Projection Television "power fuse" Questions

Ad

Question about Proscan Televison & Video

1 Answer

...fuse? Main power retulator? Just understand, the fuses are used to protect the circuit and TV from any short circuit or over voltage. Without any one of these, no fuse will blow up. If it was due to ...

Ad

Question about Toshiba Televison & Video

1 Answer

...the power supply, if the fuse is black it's blown if you put another 1 in and it blows again you have dead short somewhare make sure the powers off and the same rated fuse, ps there may 2 fuses ...

Ad

Question about Pioneer Televison & Video

4 Answers

...fuse, turn off the standby power switch on the front. Unplug the power cable. Open the back panel. All logic and power modules are on the bottom of the cabinet. Therer is a large power module in the ...

...fuse above power cord shows good. it shows 3 other fuses, but cant see them on top side of the 2 boards. unless they arte not reg. fuses ? This sounds like a power relay has failed. Sounds like it ...

Question about Toshiba Televison & Video

1 Answer

Toshiba 50H81 Has Power but No picture or Audio Toshiba 50H81 had the dreaded flashing power light so after checking TV forums on the net I found that the convergance ICs could be bad so I replaced ...

...unplug the set and remove the back cover of the TV - follow the power cord to where it enters - the fuse is located to the right and slightly ahead of where the power cord is attached to the

Question about Samsung Televison & Video

1 Answer

...power first check the fuse in the plug .if ok then you may need to take the back off there's a glass inside in the power supply with the power off check the first to if it has blown if it has look at ...

Question about Toshiba Televison & Video

1 Answer

where are toshiba dlp 62hm95 fuses fuses I looked at the power board online and I do not see any glass fuses. I only saw the pico fuses which you unsolder and resolder. Here's an image of the power ...

Question about RCA Televison & Video

1 Answer

fuse on the power board there might be a couple of them. if you replace them and blows again the theres a dead short someware make sure you the same rated fuse the value will be on the end of the fuse

Question about Hitachi Televison & Video

1 Answer

power surge bar. you need to open the tv up and take out the internal fuse or fuses...go and get the right type of fuses...(the fuses will be made of glass and the same size of a plug fuse) DO NOT USE

Not finding what you are looking for?
Televison & Video Logo

40 questions posted

Ask a Question

Usually answered in minutes!

Top Proscan Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1259 Answers

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you a Proscan Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...