2010 Hyundai Accent "vehicle shocking" Questions

what is causing my front end to ride rougher than it use to? dont have front shocks. but seem to be bottoming out on potholes and big road dips. what in my front end suspension might be wrong? ...

...to a good body ground, and if the tachometer is not properly grounded anyone sitting in the vehicle while the engine is running will receive a mild electric shock from the ignition coil ...

...- SHOCK ASSEMBLY NOTE: Access for the nuts attaching the rear shock assembly upper mount to the vehicle is through the inside of the trunk. Roll back carpeting on top of the rear shock tower to ...

...- SHOCK ASSEMBLY NOTE: Access for the nuts attaching the rear shock assembly upper mount to the vehicle is through the inside of the trunk. Roll back carpeting on top of the rear shock tower to ...

...this matter. It is a 2.0 engine two wheel drive truck. REMOVAL & INSTALLATION Support the vehicle safely on jackstands. Support it at a height which will allow sufficient room to reach the ...

how to replace rear shocks Removal & Installation Raise and safely support the vehicle. Support the rear axle and slightly lower the vehicle enough to lessen tension on the shock absorber. Remove ...

...change 2007 dodge 1500 front struts? Removal & Installation Independent Front Suspension ? 2WD Vehicles To Remove: Before servicing the vehicle, refer to the precautions at the beginning of this ...

...Fig. 1: After you open the trunk lid, use a suitable prytool to remove the trim cover Fig. 2: Some vehicles have a cover which must be removed to access the shock retaining nuts Fig. 3: Unfasten the ...

...ASSEMBLY FOR THE REAR SUSPENSION Shock Absorber Replacement Removal Procedure Raise and support the vehicle. Refer to Vehicle Lifting Remove the lower shock bolt. For right side only, remove splash ...

...Inspection Shock absorbers dampen the compression and rebound cycles of the springs. If a vehicle is not equipped with shock absorbers, the up and down motion would continue making the ...