2010 Ford Expedition "connecting speed controller" Questions

i have a 1998 ford expedition eddie bauer with front air bag suspension and after driving for about 45 minutes the air suspension light comes on. what's the problem and how do I fix it here's some ...

EGR flow in our 2000 Ford Expedition is insufficient. What does this mean? Exhaust gas recirculation flow reduced. Could be caused by valve or gunk in the flow path. I'll paste a little bit about ...

I just replaced my transmission on my 2004 Ford Expedition, twice.. now it wont switch out of first gear, unless I do it manually, then it works fine. My speedometer is also not working. I replaced it

97 F150 4.6 4X4 supercab , code 0153 O2 sensor slow response,Bank 2 sensor 1. Is this the passenger side and sensor before the cat? Also code 1151 I have no reference for this code,not sure what it is

2005 Ford Expedition (4wd) with trouble codes p2104 and p2112 completely cuts off at low speeds. All signs point to throttle position sensor, but want to make sure I'm on the right track. Shown here ...

when selector switch for ac/heat is in panel position it will blow thru vents until speed is increased then will blow only thru defroster. help! Look for a vacuum line passenger side rear under hood ...

ABS brake module sounds like a motor running and won't stop unless battery is disconnected. what is fix? I would pull the fuse for the ABS hydraulic pump and then put it back in and see what happens. ...

1997 expedition PO503 code, 4WD, 4.6 motor, changed coil pack and spark plug The code is specific to the engine speed sensor located on the side of the transmission near the output shaft. This device ...

My cruise control does not work. The light comes on when I set it, but it does not engage. Checked the fuses and replaced the speed control sensor, still not working. What speed control sensor ? ...

turn off car air conditioner blower stays on Sounds like a relay, search the web for location on your specific vehicle. Also check the knob for function. Sometimes the knob breaks and then does not ...