Question about Minolta Office Equipment & Supplies
my konica minolta has a false misfeed showing at fuser area no paper inside the fuser unit or the duplex area Check all the sensors, the sensor in the fuser unit might be broken, common thing
...fuser area in rear of machine. Check there by opening rear door and sliding the black paper chute left and downward to look inside fuser area. Look for paper or a worn fuser such as black marks or ...
...area on top of the fuser. I bought a new fuser which was cheaper than the hourly rate of $380/30 mins for the Xerox tech to visit. What else, besides the fuser. could be causing this jam. All rollers ...
Question about Minolta Office Equipment & Supplies
...fuser area or duplexing area. Open rear of the printer by removing the fuser in the back. Carefully check the fuser for paper and or damage to the sensor flag (small black flag in fuser paper path). ...
Question about Canon Office Equipment & Supplies
fuser section of the machine. Unfortunately this area this area is not for users to access. You will need to remove covers to get to the fuser unit. You may be able to access the paper by removing the
Question about Minolta Office Equipment & Supplies
fuser area as fuser gets extremely hot. Check condition of fuser roller and clean using isopropynol or recommended cleaning fluid. If fuser is damaged it may need replacing which isn't cheap sadly
Question about Minolta Office Equipment & Supplies
fuser film covers the heating element. Open the back panel, and examine the area where the paper exits. The grey film should cover the same area as the lower black roller. If not, you will either need
fuser area open the fuser roller area( clear paper jam the rollers are hot wait until it cools down get some spray silicone(similar to wd 40 with a plastic tube to reach small areas spray small amount
Question about Konica Minolta Office Equipment & Supplies
what is the fuser? The screen says the fuser has a jam. Number 01 Area is fuser check paper that at area
Question about Canon Office Equipment & Supplies
...the rollers This should be done by a trained certified engineer WHEN YOU TURN OF MACHINE MAKE SURE TO OPEN DOORS AND WAIT A FEW HOURS SO THE FUSER AREA CAN COOL DOWN CAUTION THE FUSER AREA IS VERY ...
76 questions posted
Usually answered in minutes!
106 Questions
93 Questions
72 Questions
72 Questions
66 Questions