Question about Optoma Office Equipment & Supplies
...power on for few seconds then flashes. plug in turn on main power switch and standby power light flashes. Then press power button and power light will burn solid for a few seconds then goes to ...
shuts off. The power light goes to red and the status light blinks green. AFter a few minutes the power light stays red and the status light cuts off completely. Turns on Hi, have you check the filter
Question about InFocus Office Equipment & Supplies
power problem with infocus lp70+ projector The light from my infocus lp70+ projector flickers kind of like a regular bulb that's going bad, the unit turn off by itself after a few minutes and will not
Question about Sanyo Office Equipment & Supplies
...power light turns green at first but after a few seconds it turns flashing red. the old bulb exploded on this projector. Could be a burnt capacitor on the circuit board. Replace capacitor if you can ...
Question about Sony Office Equipment & Supplies
...Power ON/Standby LED flashes. Sony VPL-EX1 turns on for a few minutes and then the Lamp /Cover LED and Power ON/Standby LED flashes. I have cleaned the air filter and also reseated the lamp without ...
...few seconds, and then the power and lamp lights would be red, I fixed this by taking the lamp out, plowing into the power conectors, then i tightened the screws down as tight as i could, then it ...
Question about Office Equipment & Supplies
ViewSonic pjd 5122 unit only runs few seconds and the power button turn red and shuts off my viewsonic pjd 5122 runs few second and the power button turn red and restarted bad battery
turns of the lamp and begin to cooldown and go back to idle mode. Can it be the lamp even though I see image for a short time? Does anybody know where to find a repair manual Not the lamp - if it were
Question about Radio Shack Office Equipment & Supplies
power button flashes red and the projector turns off few seconds after power is turned on cinego 1000 Power button flashes red and the projector
it first enters standbymode. After a few seconds in standbymode it turns on again by it self. The projector is brand new. It is imposible to turn it off! Try holding the power button for a few seconds
6 questions posted
Usually answered in minutes!
148 Questions
97 Questions
97 Questions
61 Questions
52 Questions