...power button immediately or within a few seconds starts flashing red. Other times it will interrupt itself while projecting, switch off the lamp, and flash the red light. The button flashes red for a ...
...power light flashes green for approximately 60 sec. then the Lamp light turns red, and the power light flashes red. Nothing is projected. I have contacted Hitachi, and was told to replace the lamp, ...
...There is no entry in the manual for 12 red flashes. Lift the pin 5 24C16 memory, connect and solder the pin being connected. Press the power button and then disconnect the line. You are ready to ...
Question about Panasonic Office Equipment & Supplies
...RED with POWER BUTTON orange light. If LAMP INDICATOR light is illuminated RED than lamp runtime has reached 1800 hours. but projector still working. If LAMP INDICATOR light flashing RED than lamp ...
...after I switch on the projector after a few minutes lamp and power indicator get red and flash then picture vanishes Red lamps flash but picture doesn't disappear. 100hrs remaining on filter
Red power, blinking red temp My projector starts up several times before the power light turns red and the temp light blinks red. I have checked the cleaned the air filter, but I still can't get it to
Question about Radio Shack Office Equipment & Supplies
power button flashes red and the projector turns off few seconds after power is turned on cinego 1000 Power button flashes red and the projector
...power light green the lamp light flashes green for awhile then goes red. Replaced the bulb same problem. I unplugged it then held the power button on and plugged the power cord back in. it started ...
...power light flashes green for 10 seconds or so and then the LAMP led flashed red. Replaced lamp but still same problem. Reset the lamp hours. Here is the manual on how to reset lamp time. ...
Question about InFocus Office Equipment & Supplies
...red and the power/stanby indicator is red Hello, In attempts to get your IN15 projector working, please try the steps below. Disconnect AC power from the projector and wait for 10 seconds for supply ...
6 questions posted
Usually answered in minutes!
148 Questions
97 Questions
97 Questions
61 Questions
52 Questions