protect mode because there is an internal fault. The TV must be tested and repaired at component level. Call Mitsubishi at the number listed on the user manual. You can also read my comment explaining
protect mode. The TV does not turn on because there is an internal problem, like a short, a bad voltage, or more commonly a faulty component (IC , capacitor etc.). The tv is in protect mode, try first
...not turn on at all.is there a code for 2 blink red light i should know about. 2 blinks is +B OCP protection. The manual states "Short circuit of power supply system in each circuit." and "Goes to ...
...protect mode. In protect mode higher voltages from PSU gets shut down and TV remains in standby.(see also Why my TV does not start up and remains in...) Try first leaving the TV power cord unplugged ...
protect mode. The clicking sound that you hear is the protection circuit switch that keeps turning the tv off. Common causes for TV in protect mode are: horizontal deflection and convergence problems
...turns off immediately after turning it on. I believe it is what you described as going into protection mode. Especially since I had been playing with the convergence just a week before that ...
Question about Sony Televison & Video
Is the t603 and r672 part of the tv or the actual circuit breaker Three blinks - B+ over voltage protection (OVP), unit goes to the standby mode then displays the 3 blink fault. This is also a problem
...why? mitsubishi vs-50605 Your TV set is in protect mode .To protect further damage of some component parts.There is something internal problem inside maybe there is a shorted. Good luck; Regards: ...
...protect mode, with a flashing led, that is a step forward, means that the jungle IC (The IC4511) had detected the fault. Start testing following the procedure at page 44, or same page on your version ...
646 questions posted
Usually answered in minutes!
Step 2: Please assign your manual to a product: