Question about Mitsubishi WD Televison & Video
...power. TV turns on again but then I get the same thing, TV turns off flashing red status light 3 times and one long red. Once the status light blinks 3 times, this is an indication that there's a ...
...red flash and then the sequence repeats. I can clear the status by unplugging the TV power. TV turns on again but then I get the same thing. I can clear the status by unplugging the TV power. Once I ...
...power up then red flashes again. Press and hold the "Device" and "Menu" for 5 seconds and see what code comes up....... 12 No error detected 22 Recovery from momentary Reset 32 Lamp Cover open 33 Air ...
Question about Mitsubishi WD Televison & Video
...power button, after this i get a blinking red status light, 3 quick flashes then 1 long flash repeating endlessly, i cleaned the air vents and reconnected the lamp, with no effect..... ideas? i also ...
...red blinky lights, hold down the Device and Menu buttons together for about 5 seconds. The Power light will start to flash in a two digit sequence. For example, 3 flashes, then 7 flashes = 37. Here ...
Question about Mitsubishi WD Televison & Video
...power board 6 months ago and the TV worked fine after words. A steady red light: there is a short on the DVI cable from FMT to DMD disconnected Mitsubishi V26 error code 41 with solid red status ...
...red. I turnern power off at surge protector and truned it back on the light status light was out. Turned on set herad fan runnign picture came on with the display message asking if the lamp was ...
Question about Mitsubishi WD Televison & Video
...Red Off Low Power Fan Stopped Off Red Off " Circuit failure (short or DVI connector unplugged) Abnormal LED Indications Error Codes "DEVICE" & "MENU" Error Codes Description 12 No error detected ...
...Power button, the status light and lamp lights will come on. The lamp light will turn off but, the "status" light is still on and flashing. Is the status light yellow or red? If it is yellow, then ...
Question about Mitsubishi WD Televison & Video
...power led symptom. After putting the set back together I get the steady red status led and the error code indicates 41 (short detected). Any suggestions. PS. I replaced two caps on the power board 6 ...
142 questions posted
Usually answered in minutes!
1,423 Questions
661 Questions
252 Questions
240 Questions
221 Questions