Dewalt 18v Battery Hammer Drill Dcd950 Dc925 "screw bits loose" Questions

...loose using some grips to hold the drill steady. Now that piece is out, the nose will not rotate to tighten or loosen the jaws that hold the bit! Is there any steps I might take to try to remedy this ...

...screw driver to try to push the collar forward so that it will release the bit. You may need to gently hold the handle of the impacter in a table vice or something like that to steady the tool, then ...

...times, but that seems to do nothing yet. HELP!!!! Get a torx bit, either 10 0r 15 & slowly undo screws about one third. There should be 4 of them. When screws are loose they will take pressure

...screw inside them most of them are left hand threads just back it out and tap the chuck loose with a hammer .Make sure you know the threads of your chuck when you buy the new one most are 1/2-20 but ...

...holds screw driver to use a drill bit. Instructions? Turn your drill speed selector to "1" and put drill direction in reverse. Hold the outer end of the chuck and push the trigger. Should come

loose I assume you have a ratcheting "one handed chuck". ther's only one way to tighten them and you don't get the same grabbing force. The only thing I can suggest is to try to eliminate abrupt stops

...screw bit comes loose. Every time I tighten it it loosens again. On this particular tool, you can't really tighten the bit in the anvil like a bit in a drill chuck. The bit is free floating but held ...

...loose and the screw bit holder will fall out. I have stopped using this drill since it was too frustrating and I woild like to fix it. I bought it as a tool only for $99 so if fixing it is more than ...

...ok then. Give it a quick spray with wd40.If there is nothing in the chuck check that the left hand screw in the center of the chuck has not become unscrewed and screw it back in (Anticlockwise) it ...

...bits It seems to be stuck and want tighten down Check to see if the left hand screw donw the center of the chuck came loose. When this happens the jaws will close on the screw head and appear to be ...