Dewalt 18v Battery Hammer Drill Dcd950 Dc925 "chuck won 39" Questions

...chuck just clicks but won't change bit size? put alot of pressure on 18" bit and after chuck had to be loosened with channel locks. no chuck key. now top end just clicks and spins but ...

Chuck won't hold bit when making drilling a hold or trying to reverse a screw, etc. Sorry I didn't include this information it sounds like you will need to replace the chuck on the drill. ...

won't open back up. the chuck on my new makita drill is stuck with a drill bit in it. It won't open back up. This is caused by tightening the chuck using the drills power, if you clamp the

...won't work as the chuck will just loosen when you hit the allen wrench.  I have on occasion removed one by doing the following:  Turn the chuck fully open then secure it in a vice ...

...spin the chuck to its widest opening,, and give the one jaw that won't slide in a few small taps with a flush head hammer, once it goes back, lube with a spray lube Like WD-40 or better Tri

...chuck off the shaft If it won't close the only other option you have is to break the outer collar and use a chisel to hit on the exposed jaws inside the chuck. I have detailed instructions in the ...

chuck off.  If it still won't break free, try putting the drill in a vice or use a screwdriver with a hex nut molded into the driver shaft so you can use a wrench for some

CHUCK WON'T TURN WITH THE MOTOR RUNNING. YOU CAN HOLD IT IN YOUR HAND AND FEEL IT CLICKING AND HEAR IT WHAT COULD BE WRONG WITH IT? I'VE WATCHED SEVERAL ON LINE FLICKS WATCHING THEM REMOVE

motor spins chuck won't. there appears to be a noise like a loose bearing. Could this be a transmisson? THE MOTOR CLUTCH IS DEFFECTIVE

...chuck a bit further to get it tight enough that the bit won't slip.  When you get used to it, sometimes it's easier to hold the chuck lightly and turn it by lightly squeezing the ...