Husky Husqvarna Chain Saw 240E w 16in bar "screws work" Questions

screws Before replacing old 3-way switch, mark the wire connected to dark-colored screw Connect that wire to dark-colored screw on new switch. If you are confused which wire goes to dark-colored screw

...If the setting of the screws has been totally upset, start with the screws about 2 turns out from the stop and work from there until it starts and runs, then you can set the optimal running

...It should just open a little bit the carburator butterfly. Second full close both ''L'' and ''H'' screws (turn clockwise). After open both ''L'' and ''H'' screws 1/2 to 3/4 turn (conterclockwise) ...

it dont idle You can try to adjust with L screw. When starting a chainsaw it is best to put the screw to 1.5 turns from the end. Then set the idle. There are screw for minimum (the chain must be ...

...dave The screws are for high and low. Start by tighting the screws . Then unscrew both about 1-1/4 turns. Work on one at a time. Get the high adjustment dialed in first, then work on the low or

How to adjust ticover There will be three screws on the side of the carb, a L screw, this will adjust the fuel mixture from idle to half throttle, a H screw, this will adjust the mixture from half ...

The adjusting screw mechanism does not work. I assume you are speaking of the bar adjustment screw. Remove the chain and bar--check the operation of the screw and the small prong riding the screw ...

saw idle's to fast . Where is the adjustment screw to back off the high idle There will be three screws on the side of the carb, one marked L one marked H and one marked I or T, the last two are the ...

ON THE CARB THERE ARE TWO ADJUSTMENT VALVES, ONE IS RED WHICH ONE IS THE IDEL ADJ? RICH Any screws that are capped ( anti tamper ) are fuel mixture screws, the idle screw will not have a cap, it works

...work. Assuming the carb isn't contaminated with debris I would check / reset the carb settings. Lightly seat the low and high speed screws and back them out 1 1/4 turns. Try so start saw...if it ...