Onkyo SKW-200 Subwoofer "connect receiver rca" Questions

connect your subwoofer, if you have only one RCA sub out on your receiver the other end of the RCA connector cable goes into the left input on most powered subs, there is no loss of signal, the option

...rca jack connector for attaching to the receiver. look at the new receiver connection diagram. any output that is rca designed for use by a recording device will send a signal that the 901's can see. ...

...connect the stereo's subwoofer RCA out to one of the Subwoofer RCA input jacks? Or do I hook up all the speaker wire of the Subwoofer for the High Level From Amplifier ''In'' AND High Level ''To ...

...connect Jensen subwoofer CS10 to Yamaha Receiver HTR5660 If anyone could help - Does the yamaha have a subwoofer line out RCA type jack? Most receivers with 5.1 output will. Just insert a male rca to ...

...receiver? Connect the receiver's Subwoofer Line Out to the Sub's Line In with a single RCA cable. Not knowing your specific receiver I can only advise that you get into its setup and 1) tell it you ...

...receiver. This is done by running a RCA connector connected to one of the unused connections to the amp. However, this doesnt ALWAYS solve your problem. As in my case. I have a Pioneer 7.1 receiver, ...

...connect it to what ???. Assuming that its an AV receiver. Start by connecting the front three speakers to the the amplifiers speaker sockets labeled Left front / Center / Right Front. These are ...

CONNECT TO THE RECEIVER.. THING IS MY RECEIVER TAKES THE SINGLE MONO PLUG.. SO I BOUGHT THE DUAL SET OF RCA PLUGS THAT CONVERTS INTO A SINGLE PLUG AT RADIOSHACK AND TRIED TO CONNECT IT BUT HAD NO LUCK

connect jbl psw1200 sub? psw-1200 Well, it depends what you're connecting it to.... If it's a stereo receiver or Hi-Fi amp, then the speaker cables that would normally go direct to the front L & R

...receiver has single RCA-type subwoofer output. Subwoofer has dual-right/left RCA input and output connections OR speaker terminals. HK suggested using a Y connector for RCA connection Any issues with ...