Patton Electric Patton PUH680-U Electric Utility Heater 1500-Watt "thermostat switch" Questions

...switch that is normally closed. The fan relay lets the 2-wire thermostat simulate a 3-wire thermostat. It's possible, but usually it's easier to just get a 3-wire thermosts. ...

switching thermostats switching from honeywell model t841a1712 to honeywell pro3000 thermostat and not sure where the wires go http://www.toad.net/~jsmeenen/wiring.html Go to this site and you will ...

...thermostat that I want to switch with a Honeywell RTH3100 it is non programmable. Could you explain the two wires on the left side of the simple comfort thermostat? The two wires are the control ...

thermostat is digital, look to see how it is mounted to its sub-base and remove it. If the system stops, you may have a bad thermostat or the Fan switch is in the On position. Hopefully this will help

...thermostat? I have to walk downstairs, flip a "light" switch up and the fan and heat work.  The dialon the new thermostat dictates heat ok, but the furnance will not stop and so I go downstairs ...

...switch to Centigrade they don't set to the Farenheight temperature that we have programmed. ie we have the hold temperature set at 70 degrees Farenheight but when the thermostat switches itself to ...

...switch thermostat in the off position (between heat and cool ) . I suspect that is probably a bad control board or thermostat . How do i diagnosis this further ? - Thanks If you are able to shut the ...

...thermostat to Off on Heat/AC and manually turn Fan Switch to Manual On for 10 seconds. Then Fan Switch back to Auto. I then turn the Heat Switch back On and the inducer motor restarts and every ...

...to turn it on instead of the manual switch. The voltage at the switch is .57 volts. Make sure to buy a low milli volt thermostat, then just take the switch off and hook the 2 wires to the