...getting stuck, but if the feed dogs ( moving part under the cloth) are down than the cloth can't move. Also, the pressure of the foot may be too high; this can also happen accidently while cleaning. ...
Question about Sewing Machines
The stiches On my Singer capri 40 are very loose On the downside of the cloth. The machine gets stuck after a few stiches. I have that issue when my needle is dull, have you changed it lately
Question about Elna Sewing Machines
...Getting error message 1. Something stuck 2. cloth too thick 3. needle bent I have checked everything and put in new needle. Still getting the same warning when start my elna 7200 get error 1 and ...
...cloth stuck between the hook and throat plate. Remove the throat plate (silver plate with a hole the needle goes through), usually there are 2 screws on either side of the plate that need to be ...
...cloth and get stuck underneath, please help Check that the thread is tight around the bobbin. Make sure that the bobbin is in the right way around - the bobbin thread should double back on itself ...
Question about Singer Sewing Machines
...stuck in. Any suggestions? Unplug your machine and use a cotton swab in and round the button area. Hopefully enough of it will get in there and dissolve the gunk that is jamming it up. If ...
Question about Janome Sewing Machines
getting accumalated on the reverse side of cloth. It's driving me crazy.I need some sincere advice n help. Thanks in advance, Sincerely Radha.T This is a tension problem. In addition to the top thread
...stuck, which is caused by the bobbin moving too much. this i my first computerized machine at first it was fine, now it just jams up because of the bobbin case. i also obtained a replacement bobbin ...
...stuck. Help! It is likely the the bobbin holder is jammed up with cloth or thread. Take the bobbin holder out and turn the machine by hand, if it does not move it could have a broken timing belt or ...
Question about Janome Sewing Machines
...stuck? Is the needle bent? Is the cloth too thick? Will not start again for about 30 minutes. If you've had it in for repair four times, then the technician is not doing a good job. Take it back and ...
224 questions posted
Usually answered in minutes!
764 Questions
337 Questions
294 Questions
223 Questions
181 Questions