...replacement belt (hooking it around the motor and roller, using the roller for leverage to stretch out the belt until you have the roller in it's compartment. Replace cover Put clips back in
...roller won't spin. I can see the belt isn't moving when I turn it on to vacuum carpet. If the belt is broken, how do i open it to replace it? The screws look more like tiny grommets ...
...unusual noise; if you stop using roller vacuum operates normally When you set the roller back in place, you probably didn't get it set in the slots properly. May be raised up slightly on one side. ...
...replace the belt. After you remove the roller assembly put the new belt on the pulley inside the vacuum first, then install the belt on the roller assembly and then reinsert the roller assembly back ...
...replace the belt. The belt is what turns the roller brush, and when it is stretched or worn it doesn't. You can get replacement belts here: Replacement Vacuum Belts the roller should be rolling ...
...vacuum roller bar? bissel prolite vacuum gear for roller belt does not turn Hello, this is Ava with Think Crucial. There are a number of reasons why your brush roller has stopped moving. General ...
...replace brush roller? Turn your vacuum over and there should be 5 or 6 Phillips screws that hold the base plate on. Take out those screws and that will give you access to where the brush roller is ...
...replace the roller take it all the way out. Remove any carpet fiber, string, or hair from the roller with a scissor. Step 5: After you have removed the old belt, slide the new one back on the middle ...
stick and motor shaft spins against belt causing melting. remove brush roller, clean out end berings and see if ends spin freely or if they stick. if they stick, you might need to replace brush roller
145 questions posted
Usually answered in minutes!
1,137 Questions
143 Questions
96 Questions
50 Questions