4805 Lamp & Remote I was watching a DVD on my 4805. I left the room and when I come back there was no picture. I appears the lamp is not working. It only has around 300 to 400 hours. I removed the ...
power supply projector getting on but lamp not glowing it seems that there ate 3 reasons for it 1,the lamp is failing 2,the lamp ballast is failing 3,the motherboard is failing We supply original ...
Question about InFocus Office Equipment & Supplies
...possibiltiy is the power supply for the lamp has failed and your old lamp may not be dead quite yet. If you are sure the old lamp did fail then most likely the problem would be the above #1 ...
lp640 infocus 1 red light blink lamp is not striking after 5 tries. try new lamp. if it still doesn'r work, you need to have the ballast replaced. Hello, This means that the lamp didn't strike after ...
Question about Dell Office Equipment & Supplies
...came back on but about 10 minutes later it went off again. Now it is doing what I described above. Lamp is burned out or makes a popping sound. When the lamp reaches its end of life, it may burn out ...
...blinks of the status light.[1] If it blinks at one cycle (0.5seconds On and 2.5seconds OFF) : Lamp cover error or lamp housing error. Replace the lamp cover or lamp housing ...
Question about Optoma Office Equipment & Supplies
...lamp fail comes on (tested lamp in another projector), powers down and enters normal flashing green state. I suspect the lamp supply. any comments? The lamp might be burn out or you do ot have the ...
Question about Toshiba Office Equipment & Supplies
Projector Lamps for the Toshiba TDP-MT8 DLP My first lamp failed after 900 hours, I purchased a second lamp part number TLPL-MT8 from partstore.com. The fan failed after around 250 hours. Can the fan ...
Question about Nview Office Equipment & Supplies
...and then it turns red. What is the problem? Hello, Well the single re blink of the LED indicates Lamp failure. Though most likely there can be a few other causes for your lamp not lighting. here's ...
failed to start after replace a new lamp module Failed to start after replace a new lamp module in optoma projector dlp in ds309 2 red light flash be sure to reset the lamp hrs, always a good idea to ...
75 questions posted
Usually answered in minutes!
148 Questions
97 Questions
97 Questions
52 Questions
43 Questions