...put my head into the dishwasher to check on a buildup of residue this black glue all over the inside. Repair man stated it was animal fat. After spending some time looking at the situation under the ...
...glue, then daul compound high heat epoxy....finally i ripped the inside window off, covered it w/ tape, making sure i put the tape layered starting at the bottom so the water falls over (like roof ...
Put everything back together and enjoy the fact that you didn't have to pay some yobbo $75 to come to your hous and do this for you! (HINT: When screwing the gear-like fitting back into place, use
...Put back plastic caps . Reconnect power and water hoses.8. Repeat from time to time when you don't hear the start and stop water fill. I got the same error and took all the water out of the ...
...glue which held the impellor in place properly as i felt resistance when i put the magnetic end back into the coil housing, but again no luck, it will fill to the required amount, the heater is ...
...glue. I then put 6 little bolts through to give it a mechanical seal to resist the pressure. See the picture to get a better idea of what I did. Once the bolts were in and tight I ran epoxy into the ...
glue into this black mess. We freed the wires and ran the dishwasher without the door cover on and it ran fine. We also read about the suggestion of encasing the wires into a bike tube and we did that
...put the rest of us! Now I need to find, order and install the replacement. I can see it will screw in, so it is not a difficult install....if I can get the part Well, I've super glued the frail white ...
...glue that will need to be cleaned up but I can do that later. I found a C&K momentary push button switch that fit in a 1/4 inch hole. I drilled the front panel in the center to accept the switch. ...
126 questions posted
Usually answered in minutes!
71 Questions
73 Questions
59 Questions
41 Questions
70 Questions
