Onkyo TX-SR576 7 Channels Receiver "standby light reciever" Questions

...standby light will flash rather than stay on, pressing the button then resets the light without the clicking sounds. I fear that there's no easy fix. Sounds like the power supply or the board which ...

standby light is on and i can't turn my reciever on or off. the standby light is on and i don't get anything. The stereo doesn't turn on or off. Try to use the control panel switch to turn on. Or ...

standby light on pioneer vsx-d308 receiver we had a power outage the other day. The reciever is now stuck in standby mode. Does anyone know what button combo I have to press on the reciever to get it ...

...standby light blinking Even i dont have any cables nor speaker connected to the back of my reciever unit turns off and standby light keeps on blinking. Sometimes power up normaly but at the end it ...

Standby light is on. Tried resetting it from the back but didnt work. Please advise A standby condition can mean a fault in the receiver. voltages in the system are off. This can either be a bad diode

...standby light blinks. does not stop . then i hit power button it clicks, stops blinking momentarily then resumes blinking. no display ever appears. I have the same problem. Earlier it got sorted out ...

...standby light flashing, when I turn power back on it powers up for a couple seconds and then shuts down with the standby light still blinking, I have tried to unplug and reset with no luck what's up? ...

...standby light will come on and when i press power, the stand by light just turns off It sounds like the output transistors may be putting this into protection mode causing the unit to shut down to ...

...standby light the unit will only turn on for a few sec, due the standby light Just inside the unit your power cord goes into a blackbox (like a coil of wire) that regulates the actual power the unit ...

...standby light. Unable to turn on at this point. Any suggestions appreciated. Thanks regarding the Pioneer VSX-912 blinking standby light. This is how you reset it; press the "advanced surround" and ...