Onkyo TX-SR706 Receiver "amplifier shuts volume turned" Questions

amplifier shuts off again with same symptoms. After turning it off, if it the mult-zone is turned on instead of main zone, the amplifier shuts off instantaneously. So basically turning muli-zone turns

...amplifier when iwant to turn the volume high it always automatic shut down? You need to make sure you ohms are correct if there too low this will happen to protect the amp. This is generally related ...

Amplifier from blowing up: If you listen closely when it shuts down ( after a loud scene ) there is likely a loud 'Relay Click'.. If this is what is happening you might be able to verify it by turning

...amplifier output power is exceeded, the DCP501 shuts down the amplifiers. Turn down the volume a little and switch the DCP501 off and then switch the DCP501 back on and the DCP501 should now work as ...

...shuts off when volume reaches -21. I can turn off system and turn back on and it works as long as I don't crank the volume up. I have never had this problem before. I just moved to a new address and ...

...it than it wants so it gets hot and shuts down.Put a four ohm wirewound resistor ( from Radio Shack ) in series with each surround speaker to reduce the current flow through the amplifier

shuts off at high volume Amplifiers are designed that way to prevent overloading. One reason why it would abnormally shut off is if the speakers winding are shorted out. If you smell burnt enamel from

...shuts off. phase control flashes,now it won't turn on at all. could powered subs destroy it? One of your speakers must be internally shorted. Go into the MMAC menu and turn off one speaker at a ...

when playing the DVD when you turn up the volume the amplifier turns off. Amplifier and an over load issue and is shutting down to protect the circuits. Needs to be checked out by tech.

...shuts off as volume is turned up beyond about 45. I have checked the speakers and they seem to be wired correctly. try connecting only 1 speaker at a time. try it on each of the binding posts ...