Question about HP OfficeJet Office Equipment & Supplies
...cable from printer when the printer is powered on and wait for 20 seconds. 2. Then, press and hold # and 6 while plugging in the power cord. Continue holding until it displays Semi Full Reset message ...
...front even beeped like they normally do. I solved the problem, and thought I'd share a diganosis guide with you since a lot of other people seem to have this problem and no solution. In summary, ...
Question about HP OfficeJet Office Equipment & Supplies
...cable (if you are not using a surge). 3. Else , Try a different wall jack 4. You may even try taking the printer to a different room and then check if you get some power. Now if the printer powers up ...
...front (or back) of ink cartridge. If this 'warranty expiration date' has expired, then potential cartridge failures can occur due to internal corrosion, etc. NOTE: Unfortunately, alignment pages and ...
Question about HP OfficeJet Office Equipment & Supplies
...front panel of the Phaser 7300. I cleaned the contacts with alcohol and a Kimwipe, cleaned the LED's with the alcohol pad, no luck. Turned switch off, then back on. Cleared error, then attempted to ...
...fix the issue every time for me. 1) If you are looking at the printer FROM THE FRONT, remove the right hand side cover. On most HP printers, there are 2-3 tabs on top that will either pop out with a ...
Question about HP OfficeJet Office Equipment & Supplies
...Fix your HP Photosmart D7360 (Reset Code/Master Reset) ***1- Turn off power and unplug from power source.2- Open right side of printer (looking at the front).3- Disconnect,by pulling gently, both ...
Question about HP OfficeJet Office Equipment & Supplies
...Failure Oxc18a0001" Are you able to help. Thanks I had the same problem and this is how I fixed it... It is hard to get the cover off (and it's not the top cover, but the one on the right side as ...
...Fix your HP Photosmart D7360 (Reset Code/Master Reset) *** 1- Turn off power and unplug from power source. 2- Open right side of printer (looking at the front). 3- Disconnect,by pulling gently, both ...
fix my printer. There are several solutions to this problem. Solution 1: 1. Press and hold "left arrow" key 2. Press the "setup" key and release both keys 3. Press and release the "OK" button 4. Press
1,534 questions posted
Usually answered in minutes!
2,817 Questions
1,584 Questions
1,223 Questions
857 Questions
782 Questions