Kenmore 659 Electric Dryer "seems work high heat" Questions

...work. I check ed the control circuits and the different resistance values seem to be there. The heatin element is 12 ohms and the parallel circuit is 10K for medium heat with 2.4K added for low heat. ...

...high heat. I don't know if it has a thermostat that might be bad or maybe part of the heating element may be bad. My landlord is considering buying a new dryer. Any advice will be sincerely ...

...the air setting ... none! Hi , the high temperature causes the heat sensor does not work properly , in delicate setting are having heat , the heat sensor are busted or open elements was not heating

seems to work fine. I purchased a new blower housing and fan but I do not want to replace it if I should also replace something else. Could this be some sort of heating issue? You will need to replace

...seems to run on low heat. dryer only runs on low heat. whites high heat cycle does not seem to work. Make sure dryer is unplugged. Take the back off and you will see two heater exchanges and probably ...

...high heat not working. Stats seem fine? Question edited to add Maker. Question moved to Hotpoint. Most dryers have 2 elements, one for low, and one for medium. High heat is both elements together. My ...

Our Bosch Axxis 5401 has stopped drying...the cycle works fine, but it doesn't seem to be producing any heat. The heat transferer has been cleaned and the condensation hose has been checked and is all

...seems to work as normal, but no heat? I'm thinking bad selector switch, but hope not? There are normally three devices controlling heat overload, but I don't see them in parts lists. Thermostat, high ...

...and everything else seems to be working ok Check the thermal disc with an OHM meter. One will be next to the heat element (high limit) and another on the air exhaust area which is the low

Electrolux Dryer Model EDE37100W: My dryer heats up for 20 minutes until a 1/2 hour and then an red error light goes on. After cooling down for a short while it works again. What is the problem? I ...