Digi Channel Master/tal to Analog Converter/CM-7000 "ground tv unplugging" Questions

...TV. Had been working fine before this. This is a common problem. There are several capacitors on the power supply and logic board that are bad. Replacement of these parts has restore all units that I ...

dish network vip622 freezes and needs to be reset... just to freeze and need to be reset again and again. Dish thinks it is satellite signal and is sending someone to the house. Some websites point to

all i get is the welcome screen and no light by the standby button. it has power If normal operation has the welcome screen dissapear after a few seconds followed by working properly, it appears the ...

... the cable is not severely bent. Those are the easiest causes some more complex are faild diplexers,ground blocks, lnb or cabling. Two more easy possible causes are dish misalignment due to wind, ...

...or Panasonic. Note: Caps on the logic board are extremely hard to replace due to the internal ground plane. Contact me if this is beyond your skills for possible

...ground/bed/blanket etc, to work on (screen side down). Usually there are 2 or 3 screws (or a few more) to remove, then you will have to carefully (its comes off easily most times)insert a flat ...

...resolved the outlet itself may need to be checked out by an electrician to make sure it is properly grounded. If the problem persists after that then the receiver itself may need to be replaced, if ...

My Dish DVR 625 does the "program guide download" or "system update" at its preset time during the night, but when it reboots after the system integrity check, it does not power ...