...tightening anything. Help? :( Verify that you have installed the proper correction tape. The types of tape that can be used with this system are: Item 1030 - Correctable Film Ribbon, 1230 - ...
brother typewriter cannot change ribbon on my brother typewriter gx-6750 make sure you power on the typewriter and space bar carrier until middle of bar. flip open cover and put ribbon in rear end ...
Question about Office Equipment & Supplies
when we type it acts like the daisy wheel is not in place and the ribbon does not move The printwheel may not snapped in properly and going to it's home position. . Keep trying..it will spin to its ...
Question about Brother Office Equipment & Supplies
...tape in the GX-6500 Typewriter? Move carrier to middle with spacebar. Open lid, remove black ribbon and old correction tape. Gently pull new tape apart a few inches. attach take-up spool
Question about Smith Corona Office Equipment & Supplies
...although the characters on the screen are correct, but are not what is typed. Does not need new ribbon. The printwheel may not snapped in properly and going to it's home position. . Keep ...
...The slashes are caused from the happer not lining up with a letter. The other problem may be the ribbon may have a bind in it or be out of ribbon. There is a wheel or hole on the ribbon to mover
...ribbon. Turn the tightening wheel on the ribbon cassette and the LOT spool, so both are tight. Turn the power back on. Part of that routine it goes through is to find the "home position" of the ...
...tightening the tape until resistance is felt. 5) Replace the typing ribbon cassette. 6) Press the CODE + = (SETTING) key. Changing the Ribbon Cassette 1) Move the print carrier to the center of the ...
Question about Brother Office Equipment & Supplies
...immediately BELOW the character.. I've removed and reinstalled both the cartrige and the correction ribbon. The corrrect side of the correction ribbon is facing the page. Turned off and on the ...
Question about Nakajima Office Equipment & Supplies
Hello, The correction ribbon does not raise high enough to erase any text. It raises just enough to catch the bottom part of lower case g, j, etc. Any help with this issue would be appreciated. Thanks
273 questions posted
Usually answered in minutes!
1,135 Questions
1,072 Questions
1,012 Questions
767 Questions
733 Questions