Necchi 3102 Mechanical Sewing Machine "tight hand wheel" Questions

...tight the hand wheel is & see what they recommend See if your motor has elongated holes where it's mounted to your table & see if the motor can be moved to loosen the belt a little. It ...

hand tight only, tighten the screw in the stop motion and see if the stop motion frees off and then tightens again so the machine will work, if it does not take the stop motion wheel of again and move

Hand wheel is very tight and the needle will not go down This machine is brand new but the hand wheel will not turn easliy, very tight and then it completely stops, does anyone know what this could be

...tight and cannot be moved by hand. When I take the top cover off I can move the wheel with a pliars but not by hand. I have tried putting a little oil on the wheel and I cleaned it good but it is ...

...hand wheel toward me.... it doen't move. Saundra Have you checked the bobbin compartment to make sure there isn't a thread-jam there? It can get so tightly snarled that even the handwheel ...

...hand wheel so tights It shouldn't be too tight. Clean out and remove the bobbin/bobbin case. Now, try to turn it. Does it turn any better? If it does turn easily without the bobbin case and bobbin ...

hand piece is very tight to turn and unable to use the machine Make sure to clean/remove all the lint, thread, dust, etc. that may have built up in the bobbin area, around the feed dogs, and under the

...Hand wheel Knob A will not move. There is a screw on Knob A that I loosened but the wheel still will not move. If you have an instruction booklet, directions on are page 20. The small box you will ...

...is tight. If it is tight then loosen the small screw (usually on front of hand wheel). Move the brake forward a little more to tighten and then tighten the small screw again. Look at my

...hand wheel is tight. How and where do I oil the hand wheel? We are missionaries in Mexico and cannot take it to a repair shop. We have replaced the fuse ourselves. It i The shuddering started ...