Question about Singer Sewing Machines
...face plate, then the plate to which the bulb is attached to oil machine. There is only one place for the screw to attach the bulb back in place, however when I try to replace the face plate it does ...
...face plate causing the needle to break. I an using a singer 2020 needle. Any instruction on how to fix my problem? Debbie your machine threads from right to left. the needle flat spot faces left. big ...
Question about Singer Sewing Machines
...face plate off, remove the bobbin, and take the housing apart if you have to...then start all over with winding new thread on the bobbin and re threading the machine before you try sewing. Hope this ...
Question about Singer Sewing Machines
face plate. It's shown on page 32 of the manual in the section on changing the bulb. The face plate is secured with a single screw that is near the front of the machine. After removing the screw, hold
...face plate and it looks like the needle is hitting a revolving disc below. Time for a tune up and the timing to be reset. People tend forget that machines do need to be serviced once in a while, it ...
Question about Sewing Machines
...face plate (catching on position finger) I was quilting and my thread kept breaking. I removed the face plate and removed lint from the bobbin case, feed dogs, and surrounding bobbin area. There was ...
Question about Singer Sewing Machines
...Remove the face plate by removing the single screw fastening it to the left end of the chassis. 2.To make things easier, remove the presser foot (raise the presser foot and release the presser foot ...
...remove your throat plate, now you will be able to get it cleaned out. I would oil the machine as per you manual and you should be fine. Just do NOT turn the handwheel away from you because you can ...
Question about Singer Sewing Machines
...remove the old needle.Place the new needle in the needle clamp with the flat side of the needle facing the back, (round needle, the groove in the needle should face away from the shaft).Push the ...
...Singer 301 and here is the problem. When I go to "pick up" the bobbin thread the top thread gets all tangled up in the bobbin Any hints? Many thanks! I just had this problem, too - if you have the ...
72 questions posted
Usually answered in minutes!
111 Questions
91 Questions
75 Questions
44 Questions
29 Questions