remove washer lid to replace lid lock washer has a liod lock when washing i need to know how to remove top to replace lid lock switch on crosley washer modelcaw9244x02 Remove power to the unit. Locate
Question about Kenmore Washing Machines
Remove lid of top loading washing machine Kenmore 110.92575110 How do I take the lid off? It looks like there are four screws, two each side, but the rear two are blocked by the control console. There
...Remove the lid switch mounting screws, disconnect ground wire and remove lid switch assembly. Compare old switch to the new one. If the plastic sleeve of the new switch is longer, break off at the ...
remove the lid to get rid of the rust. I have removed the screws that hold the pins to keep the lid from going back futher but still can't see how to remove it from the washer. Please help. Top loader
remove the lid on a ge profile harmony washer? Use a putty knife to remove the front panel first/ The putty knife will insert between thr top of the lid and the front panel about 2 inches in from each
Question about Fisher and Paykel Washing Machines
...remove the lid in the up position by pulling vertically to make it a bit easier,Hope this helps Cheers. select the spin cycle and press start/pause, put a small magnet along the right side, top, ...
...LID SWITCH YOU MUST REMOVE THE COVER ON THE MACHINE. FIRST REMOVE THE TWO PHILLIPS SCREWS FROM THE CONTROL CENTER ON TOP BACK OF MACHINE . TILT BACK THE TIMER AND CONTROL CENTER GENTLY. THERE ARE TWO ...
...remove the lid switch. Unplug the wiring harness and replace. The other type, do this: Then use a flat blade screwdriver to remove the brass spring clips on the left and right side of the washer that ...
...remove washer top for broken lid switch access I have a Kenmore washing machine model 22702. The lid switch plastic mounting has broken loose and so when the lid closes it is not detected and the ...
Question about Whirlpool Washing Machines
...remove them lid will slide up an off small tip when trying to remove screws if they are tight or stubborn stop they have a tendency to rust in place you may snap off trying to remove bad design if ...
401 questions posted
Usually answered in minutes!
992 Questions
874 Questions
371 Questions
398 Questions
255 Questions