Question about Samsung SyncMaster Computers & Internet
...wire only a little to relax any tension..you get about 3/4" in extra taped to panel. The hard part is done.;) Still holding the frame...Now lift the panel (where the power button assembly wiring goes ...
...wire only a little to relax any tension..you get about 3/4" in extra taped to panel. The hard part is done.;) Still holding the frame...Now lift the panel (where the power button assembly wiring goes ...
Question about Samsung SyncMaster Computers & Internet
...wire only a little to relax any tension..you get about 3/4" in extra taped to panel. The hard part is done.;) Still holding the frame...Now lift the panel (where the power button assembly wiring goes ...
goes out the cap is dicharged. You can also have a look at this page ( http://ezinearticles.com/?The-Right-Way-To-Discharge-Capacitor-In-Switch-Mode-Power-Supplies&id=64778 ) Spec is: Cap Xon, 1000 uf
goes black, but the monitor and computer are both still on. It will load and everything, but if you go to open up a program it will go black. She sent it to a professional to get fixed for a different
Question about Samsung SyncMaster Computers & Internet
...goes black monitor green power light remains ON. Power can be turned of and the display again stays on approximately 5 seconds. Replacing capacitors in power supply did not correct the problem. ...
Question about Acer Computers & Internet
...goes black for a second Shine a light on the display at an angle from the side. If you can see part of what is normally displayed, then the display backlight is faulty. If the monitor is more than ...
...wire only a little to relax any tension..you get about 3/4" in extra taped to panel. The hard part is done.;) Still holding the frame...Now lift the panel (where the power button assembly wiring goes ...
...goes from the video board to the back of the screen. Then start it and check the screen flash color. These come apart a little different than most. The front trim comes off with the screen. So ...
...color guns at their corresponding pins on the CRT's neck board. You can see their levels change as you tweak their adjustment pots on the neck board. If the red voltage is present and at the same ...
7 questions posted
Usually answered in minutes!
306 Questions
238 Questions
151 Questions
140 Questions
137 Questions