GE Profile Spectra JGBP90 Gas Kitchen Range "range bake element" Questions

...range. If not, you may need a new bake element (part number WB44T10010 ) Let me know if I can be of further assistance. Thanks for using fixya. If this helps, a fixya rating would be appreciated. ...

...range power cord (usually 5 quarter inch hex screws) 3. look for burnt off wire leading to/from bake element. If yes, 4. strip ends of broken wire and splice with ceramic wire nut if no 4. bad news. ...

...bake element hidden bake element , how can this be found? Kyle, Usually what they mean by "hidden" element means that the bake element sits in a recessed part of the oven cavity. You only have one ...

...range bake element doesn't work Replaced non-working broiler element, now bake element doesn't work, only broiler element. Bake light display comes on, but only broiler element heats up. Fuse box was ...

range Model KERC507. It will not hold a consistent temp. If I set to bake at 350 degrees, the oven will only reach a temp of 340 and then begin to decline in temp. Good chance your bake element is out

wires. Replace the back (if you had to remove it), and replace the screws that hold the element in place. Plug the range back in (or turn on power at the circuit breaker box), and you're ready to bake

...accept the bake and temperature request? If so, You will need to remove the rear panel of the range and test the bake element leads for 220 volts when the oven control is set to bake and is turned

range with es 100/105 both bake and broil elemnts come on My Bake element shorted out tonight and blew a breaker in my panel. After fixing this problem, the bake element comes on but will not shut off

...range is 2 years old. Thanks, Jon Z Check your bake element, I had the exact same problem and found the bake element had burned in half. The broil element comes on during preheat and kicks off at ...

...Bake element still do not work but burners do look inside the breaker box..find the 220 breaker to the range...make sure both sides are in the on possition....if not then only 110 volts are going to ...