Question about GE Microwave Ovens
... part number AP3187809 $56.40 plus shipping You may consider using epoxy to "glue" the handle back into place. The epoxy will be stronger than the handle itself. If you do this get the one minute ...
...handle in place until the epoxy sets,, Check for ozzing,, dribbles, and drops,, and wipe it up now,, or it will be there forever,, Sit back, put feet up, drink the rest of the beer, and watch epoxy ...
...I only need to replace the screw on teh bootm of handle. I am looking for what I need to remove to get to the problem. Where can i get a more detailed manual? get one minute epoxy and glue the
...handle on our kenmore above stove microwave pulls out at the bottom. the top is still connected. Can't seem to see how to get into door to see if it came unscrewed or do I just glue it? I recommend ...
are doing. When I realized that the springs were too strong, I weakened them, I repaired the flimsy handle several times with plastic epoxy. GE engineers did a lousy design job on this one
Question about Microwave Ovens
'ears'' poking out thru the front face plate slots, that hook the door on. Epoxy failed after 2 trys to bond, whats the correct fix. Try a Pop-Riveter, drill small hole insert rivet and squeeze handle
Question about Microwave Ovens
Need to replace the handle I have the part but how do i desassemble the door properly I have a new microwave handle but how do I replace it without tearing apart the the door to the microwave. To ...
Question about Amana Microwave Ovens
...handle. How do I reconnect it since it appears to have been riveted to the door? I would use epoxy glue allow it to dry 24 hours for maxium bonding, clamp it in place for best results, otherwise ...
...handle. Look really good on inside of door. You should be able to remove the inner panel and then have access to bolts for the handle? If not... Epoxy is your best friend at this point! Good
25 questions posted
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
257 Questions