screws that support the front of the hood. I believe they are 1/4" by 3-1/2" long. If not included, check for size. The hardwae will have them, get flat washers to fit both also. Measure from the back
...screws and screwdrivers come in various sizes. I think the size you need is T20H. You can download the installation guide here: http://www.geappliances.com/service_and_support/literature/ ...
Question about GE Microwave Ovens
size of some of the oven models, it is a two-man operation. Have a question? Get an answer from an appliance repair specialist now! Other People Are Reading How to Remove a GE Over the Range Microwave
...size that I could buy? I would nee dto figure out how to take this one out and install the new one. This one is installed over the range. If you gently push up on the door latch heads (hook-like ...
...screws, and two vandalproof ones: torx with a post in the middle. So you can have the right bit ( http://www.mcfeelys.com/product/VDB-1130/Security-Driver-Bit-Pack-30-pc ). Or, plan B: often our ...
...screws) and final screw on left side of metal "air duct" - here's where you'll need the offset screw driver (and a little patience!): Then, you can gently lift the sheet metal panel, find the light ...
773 questions posted
Usually answered in minutes!
3,405 Questions
285 Questions
308 Questions
257 Questions
258 Questions
