remove impeller from motor to replace. I 've removed all the bolts but can't remove the impeller from the shaft. If it's a separate shaft, it requires a puller tool, but first you have to remove a nut
Question about Jacuzzi Pool & Spa
...on the back of the motor which you should remove to get to the back of the shaft. This is best way to remove the impeller but its likely to be a struggle if there is rust on the shaft. Good ...
...remove the impeller and motor? Separate the plumbing portion of the pump from the seal plate which is attached to the motor. The bolts will be a 9/16 inch hex head, that are visible facing the motor. ...
...impeller is just screwed on the shaft. COUNTERCLOCKWISE to remove. Some have a screw in the center attaching it to shaft. This is removed by by turning CLOCKWISE.(reverse threads) Remove back cover ...
remove impeller on pool pump to replace seal? How can I remove impeller on pool pump to replace seal? First, separate motor and pump. Remove back cover of motor. Drive shaft of motor either has a slot
...shaft. To remove impeller, first remove screw(reverse threads) Next, remove back cover off motor. The shaft either has a slot for a screwdriver or flats for a wrench. Hold shaft and unscrew
Question about Hayward Pool Products Pool & Spa
...remove the impeller by turning counter-clockwise facing the impeller. If it will not move, you may have to use an impeller removal tool. Most pool supply places have them. Be sure to install a new ...
Question about Pool & Spa
out center bolt. To remove the impeller you will twist the impeller off in a counter clockwise motion. However, the impeller cannot be freed from the motor shaft without first securing the motor shaft
remove the impeller. To lock the impeller you will have to remove the motor end cover or a cap covering the shaft end depending on which version your particular motor has. Look at the end opposite the
Question about Pool & Spa
...remove the impeller on a mission magnum centrifugal pump? Open up the pump housing, by separating it into 2. Reveal the impeller. If there is a center screw in the middle of the opening of the ...
103 questions posted
Usually answered in minutes!
38 Questions