...switch turned ON. The white wire from the power cord goes to one of those, and the second white wire from the motor goes to the other one. When you have it all wired up, plug it in & turn it on. ...
wire (black). If there are only two wires that went to the switch, you should be able to tie them together and the motor will run when plugged in. The switch should be a common SPST type either toggle
...wire the switch up on a dewalt dw758 bench grinder That's pretty straightforward - the black wire from the power cord goes to one (either) side of the switch, and the black wire headed into the motor ...
...switch will work. You could even mount the switch on the bench in a switch housing and run the wires from the grinder to the switch and back if need be. Just be safe and make sure there are no ...
switch, joins the "Contacts" to the Phase. Positive, Wire to the "Motor". The "Other Terminal Wire from the Motor, goes to Common. The capacitor. Is installed in Parallel with the Phase and Neutral on
...wire cord. Use the switch to break the neutral and ground the case. The connections should be as follows: Connection 1, would have one of the primaries and one of the starts to neutral. Connection 2, ...
...wire from the other tab under switch to one of the three tabs under plate that is marked hot or l1 is probably #2 but you need to be sure. the white is the nuetral or l2 which is most likely #3 and ...
i have just received a new switch and have 4 wires that go to it the switch number is ht6481934 please help its simple. get a multy meter put it on continuity, that the setting when u touch the two ...
4 questions posted
Usually answered in minutes!
11 Questions
6 Questions
4 Questions
