Question about RTO Tools & Hardware - Others
..."mis fire" by Pasilode. I own the 16p Framer and the Angle nailer and I never get it from the Framer but I do get it seldom from Trim Gun,nothing you can do ,its just a misfire. Please rate ...
...fire Had the same problem with mine. Remove the 3 screws on top and remove the lid. on mine the firing pin assembly was jammed. If the roller seems to be holding the pin carriage too tight then you ...
...pin in the out position Hi, Here is a tip that I wrote about the Paslode nailers and the problems that can come up with them. I also have a link to the Paslode manuals which contain Paslode cleaning ...
Question about Dewalt Tools & Hardware - Others
...angle to get it to shoot Dewalt has a new trigger valve to replace the original (part number 5140095-73). Not sure if the new valve is replacement to address an issue or natural progression. I would ...
...It seems that the "stop" is not seated correctly. The "stop" is the small metal angled piece that stops the firing pin once nails are depleted. I know I have put it back in the ...
dewalt dc618 wont drive a nail gun lights up,when you pull the trigger the motor runs,when you press it down it will not shoot a nail.the safety is not on.the plunger will not work. problem ...
Question about Senco Tools & Hardware - Others
...pin First, check that you are using the proper nails. The FP602 needs Full Round Head nails with plastic collation. If you are using Clipped Head nails with the paper tape ...
...fire the nails in. Any ideas please? First make sure you are using the correct nails as far as gauge and angle. These are complicated tools and you may want to take it to a DeWalt service center for ...
107 questions posted
Usually answered in minutes!
5 Questions
3 Questions
1 Questions