Brand Remote Start/keyless/car Alarm Very Sleek "install hood pin" Questions

...hood pin and all is good. Any suggestions on a fix. Thanks Eric Does the vehicle have a hood pin installed ? Chances are the pin rusted out and it thinks the hood is open, that would make it not ...

...hood pin wire if no hood pin switch is installed) 2. Turn Key to the ON position 3. Press program / valet button 5 times, after a few seconds the unit will flash the lights 5 times. 4. Push the ...

...install. The locks work, flashes work upon lock and unlock. Remote start does not turn engine over and the box clicks when activated. Is hood switch required? Is Alarm Horn required? The directions ...

...install the hood pin switch? If so, does the blower and dash lights come on when you press the start button on your remote? I have one installed on my 2005 and it works great. I did not install the ...

...hood pin wire (raise hood if hood switch is installed). Apply 12volts to blue/black brake wire (press and hold brake pedal if wire is installed). Press and hold any button on your remote until ...

...hood pin wire (raise hood if hood switch is installed). Apply 12volts to blue/black brake wire (press and hold brake pedal if wire is installed). Press and hold any button on your remote until ...

...hood pin keeps bending Viper 5701 alarm installed on 2002 Hyundai at the back of the hood drivers side just right of the brake master cylinder. Every time the hood closes it bends the pin...doesn't ...

...hood pin wire (raise hood if hood switch is installed). Apply 12volts to blue/black brake wire (press and hold brake pedal if wire is installed). Press and hold any button on your remote until ...

...hood pin wire (raise hood if hood switch is installed). Apply 12volts to blue/black brake wire (press and hold brake pedal if wire is installed). Press and hold any button on your remote until ...

...hood pin switch if installed, press and hold the brake and push any button on the remote the clicking should stop. Take the ground off the hood pin switch and release the brake, then test the