Nautilus Tr300 Treadmill "starts stops e1 code" Questions

...E1 error after start up. Does the walking belt move for a brief moment, then immediately stop, followed by the E1 code? Or is there no belt movement at all when start is pressed? No movement at ...

...starts up then stops soon after. Check the speed sensor to make sure it is within 2 credit cards(flat side) distance from the front roller (magnet). Then check the sensor wire harness to make sure it ...

...is the motor controller 1 if the belt is moving and it stops after a few seconds it will show E1 problem is the speed sensor (located at the front roller on the side where the motor is hope this ...

Motor not going on York Optimum 60100 - after a while E 1 appears I have an Optimum 60100. It powers up normally – display etc works. When I press “start” – NOTHING happens (motor does not move or ...

code E1. I have cleaned and lubricated, checked that all of the wires thru the handles and control board are still connected, checked the lights in the base (which are green). What else is there? Your

STARTS THEN STOPS AND FLASHES E1 ACROSS THE SCREEN This is probably a faulty speed sensor or the speed sensor is not plugged in properly. Its also possibly a faulty motor control board or lower board.

...E1 error code the other day. Treadmill started and ran for a few seconds and just shutdown. What could that be? I have a Bodycraft TR 1160 that's about 6 years old. This conditions will be cause an ...

shows code E1 and will not start START OK NAD SHOWS E1 DEN STOP

...starts for about 5secs and then E1 code comes up and it stops 1) adjust the speed sensor, and clean it, and tight the connector very well.see the diagram2) test the main board output , for input ...

...stops. About 3 seconds we get the E1 code. I have checked the commutator and brushes, the sensor seems to be ok, the led light on the dc output board is on. What voltages should I be looking for from ...