...water pump water turned off at mains, when water reinstated, pumps will not activate You need to bleed off the air. There should be a bleed port on the housing to do this. If that does not solve the ...
pump is working, have bed airlock, water then comes out of hose, but, then dies again, do I just keep on bleeding it, had plumber around yesterday, he bled it, it seemed good for 10 seconds after he ...
Question about Little Giant Garden
...pump so it needs water to lubricate the porcelain shaft, it's not good on it to run it dry for long period of time just a short time, these pump eventually wear and will need to be replaced. they ...
...pump it makes a humming noise and will trip the reset. Is the motor no good or is there something I can check. Opening the little drain plug at the bottom should relieve the pressure and make it ...
Question about Hayward Pool Products Garden
pump on for a second or two to pop the lid off. When putting back together close air bleed and fill bottom of filter with water then put the top on and as the water tries to drain back to the pool the
...bleed the fuel right through to the injector pump. If there is no valve for the purpose you will have to loosen the pipe unions progressively towards the pump until fuel flows at all points one after ...
Question about Balboa Instruments Garden
...spa turns off all the time because of the heater? Open the drain for a few to bleed the pipes or you can wrap a rag around a hose and stick it in the skimmer pipe and force water through the
Question about Little Giant Garden
pump water. I put it in water, let it run for 1 minute, then unplug for 1 minute, alternating this five times, still nothing happens. Check the suction side and see if it is clear to allow water flow.
pump, then you are working with water that is already under some pressure. The booster pump, once it is working normally, would always have water in it and would not have to re-prime itself. To get it
trouble shooting shurflo water pump problem Have installed new pump and makes low noise like it wants to start but wont run Try bleeding all the air out of the system or the new pump might be faulty.
83 questions posted
Usually answered in minutes!
118 Questions