air lock in water pump water turned off at mains, when water reinstated, pumps will not activate You need to bleed off the air. There should be a bleed port on the housing to do this. If that does not
...it runs for 5 seconds and then stops, until the next attempt to detect water, the pump is sitting in three feet of water. The pump will not continue to run after detecting water. CLEAN AIR LOCK ...
runs but will not pump water from a sand point. You have a air lock. shut pump down refill with water and start, may have to do this a few times.
...water pressure? It is either a broken impeller in the pump or if it was just drained or new install, then an air lock most likely. Try disconnecting power, then reconnecting, then disconnecting, etc. ...
Question about Hayward Pool Products Garden
When putting back together close air bleed and fill bottom of filter with water then put the top on and as the water tries to drain back to the pool the suction will help pull the top down into place
Question about Balboa Instruments Garden
...water and no air. Or start the pump wile the drain is open. This should fix your problem. Good luck. Hi, I have a balboa 500z series pump. I had to refill the tub today and once the tub was full I ...
air locked. If under the pond be sure it is clear of dirt and you will need to take apart to check the impeller. Before you do these things check all power in and out of switches or clocks and be sure
...water pump and thermostat. Any other suggestions? My Sportsman runs bad when heated up, but if you add fuel it runs fine again. I had a pick up that had an internal fuel pump like our Sportsman's and ...
83 questions posted
Usually answered in minutes!
118 Questions