...coupling to loosen other spring clip, remove spring clip pull motor forward and away from gearbox break couplings off shaft of motor and gearbox. NOTE: new coupling sets have a metal center hub to ...
...coupling.pull clips off pump..remove pump...take 2 screws and two clips holding motor in place..remove wiring harness from motor..remove motor...replace coupling and reassemble. have included link to ...
...coupling looks like: To confirm this pull the machine forward enough that you can lean it back and it will stand back under it's own weight. Wedge something underneath the chasis so it does not fall ...
...coupling that gets stripped out and the older GE type has a spline directly on the agitater that gets stripped out. You will need to remove the agitator. The dispenser usually pulls right out. This ...
...the pump off there are clips you have to take off pull the motor out and the rubber coupling is right you will have to buy another coupling they cost about $10.00 then you put it back together. ...
Question about Kenmore Washing Machines
...coupling looks like: To confirm this pull the machine forward enough that you can lean it back and it will stand back under it's own weight. Wedge something underneath the chasis so it does not fall ...
...Pull washer out a couple of feet and tilt it back, lifting the front. Rest against the wall. The belts are on the bottom. Remove the drain pump belt, and you'll get to the drive belt. The motor is ...
...pull motor out and replace coupling...alingn motor and coupling onto gear, clamp it and return pump into its place. I am new here, tried to post a photo of what I think you have but cannot just yet. ...
...pull off the panel.Locate the pump coupling, which is the rubber part that connects the motor to the water pump, and unscrew the clamps securing it to the motor. Once the coupling is removed, tension ...
152 questions posted
Usually answered in minutes!
522 Questions
457 Questions
351 Questions
272 Questions
222 Questions