3 phase 5hp baldor motor. I believe the wiring is connected wrong making my blade spin counter-clock wise. any suggestions? wiring diagram? Thanks . Tom Simple solution: switch two of the wires. Doing
arm saw want start just hums sounds like single phasing..is this a 3 phase saw..then one leg is down...if not, then it sounds like a start capacitor. Ensure the switches have been metered and are good
runs backward If this a 3 phase saw, reverse 2 of the phases.
...table saw. I removed the motor, to move the saw. when i reinstalled the motor, the blade has moved 5/16'' towards the fence. Check to make sure the arbor set screw is not loose. The bearings ...
...table saw with 5HP motor starts instantly, runs well, but when I turn off the switch and the blade spins down, there is a rattle. Is that normal? No. Unplug saw remove saw blade grasp shaft that saw ...
...3 HP 1 Phase 230V saw that will start and run for about 3 seconds and kicks the breaker off and I put a new breaker in and still does the same thing any help. Either it has a problem with a blade ...
...table saw is. serial no is 97661400 On the Powermatic 66's the first two numbers are the year in which it was made, so yours was made in 1997. The second set of two numbers is the model. The last ...
The saw starts but ramps up slowly. Under load the blade slows down. Seems as though the motor is not getting enough power or there is an issue with the motor itself. Any suggestions? Before you go ...
...3/4 hp motor. Now this motor won't turn the blade w/o help (i.e. me spinning the blade) and once it is running it will die down to a stop and hum untill I pull the work away. Could replacing ...
...phase or 3 phase Motor- 3 phase or single phase if the plug on the cord fits any other outlet in the house it will be single phase if the cord is cut , then it will have only 3 wires if it is single ...
16 questions posted
Usually answered in minutes!
2 Questions