...2 ways you can install a belt on a Turbo Power 2000, either you can remove the bottom plate and expose the belt, 1st place the belt on the brushroll section of the vacuum then use a belt puller or a ...
Question about Kirby Vacuums
...2 How to put the belt on. I'm having a problem getting the belt on the rod The belt goes around the brushroll before you install the brushroll in the nozzle compartment, you must then twist the belt ...
...2) Worn out belt. Sometimes a worn belt acts this way. Just because it looks good, does not mean it is good. 3) Belt improperly installed. 4) Brush roll not spinning freely. (replace Brush Roll 5) ...
...2 minutes. Did you make sure the brush that the belt turns is free to move? Sometimes they get bound up and will not turn and as a result, the belts either burn or break. Remove the roller brush, ...
...install a new belt. What kind of vacuum is it you have? This must be an Eureka vacuum, On the top cover, near the from, are some slots, there is a screw on each side, remove them and the cover will ...
...2 new belts, # 38528034, and # 38528-035 There is so much slack in belt # 3852034 (brush drive) that it cannot grip the brush. There does not seem to be any adjustment to take up the slack. I've put ...
...Install self propelled belt Hello, I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure. Usually the self propelled vacuum have 2 belts and you should ...
...2 and i need help getting it back on. remove power head turn knob on front counter clockwise look in hole on back of powerhead make sure belt is on the hook install powerhead back on motor turn knob ...
...install new belt. Place new belt around brush. After pushing brush through the new belt, with belt loosely around brush slide brush back into housing 1 side at a time. The brush fits in very tightly. ...
178 questions posted
Usually answered in minutes!
625 Questions
381 Questions
223 Questions
207 Questions
187 Questions