Kirby Ultimate G Bagged Upright Vacuum "armature shaft" Questions

Ad

Question about Kirby Vacuums

1 Answer

...armature now, but I still can't get the front shaft to unscrew. BTW, I'm turning it to the right. Any suggestions? I take it the armature is not moving at all when you are turning the pulley(to the ...

Ad

...armature shaft still while I unscrewed the pulley drive nut ,which must be removed in order to remove the vacuum fan. > There probably is a special tool somewhere that would fit over the armature ( ...

Ad

...armature shaft is worn there might be a problem, but that would be about the only one, Bushes/bearings can be replaced as can brushes. If the armature shaft is worn, a fix can be formulated but it ...

...can put a nail or nail punch in the hole on the armature and tap it gently to the right. this should loosen it enough to unscrew. There's a washer, then the fan, and a spacer that fit over the

...shaft on a hoover c1433 to replace the fan or impeller. Removal of the pulley requires extreme care. There is a small opening on the side of the black motor housing to allow a special tool (or a ...

...armature shaft (now would be a good time to check the inside surface of the belt for grooves or damaged spots which would cause the armature shaft to slip on the belt). If the beater bar has too much ...

Question about Rainbow Vacuums

3 Answers

...Shaft motor and is 220/240 volt I believe the armature has burned out and I want A replacement motor or Armature. unfortunately we live in New Zealand and there is no longer any service or warrenty ...

Question about Kirby Vacuums

1 Answer

...shaft (rear of the motor - next to comutator) that allows to use a wrench to hold the armature, it may be very similar on older models. maybe a hole instead of the cut... You would have to access the ...

Question about Kirby Vacuums

1 Answer

...shaft squeaks after I vacuum then in a hour it don't squeak Dirt behind or ballbearing are you shure its the fan ? , the carbon brushes can also made sometimes a noise on the collectors of the ...

...or pry the fan and associated washer off the armature shaft. After replacing the fan and pulley, put a bead of silicon sealant on the fan housing and replace all parts in reverse order of

Not finding what you are looking for?
Kirby Ultimate G Bagged Upright Vacuum Logo

733 questions posted

Ask a Question

Usually answered in minutes!

Top Kirby Vacuums Experts

JoeVacs

Level 2 Expert

445 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

Chris Nomland
Chris Nomland

Level 2 Expert

124 Answers

Are you a Kirby Vacuum Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...