Husqvarna Craftsman 36cc, 16 In. Gas Chain Saw "set high low settings chainsaw" Questions


Question about Homelite Garden

1 Answer

...1/4 turns out( hi+lo) usually once the chainsaw has been run in, the 'hi' screw can be turned in an eighth, tickover set low enough not to cut out but high enough not to engage the clutch, cheers ...


...a poulan 2550 chainsaw trying to to set high and low fuel settings starting settings are 1 turn on high side and 1 turn on low side.most likly you will be at 1 1/2 on low side and 1 1/4 on high ...


LOW and HIGH speed screw settings what are the LOW and HIGH speed screw settings for a Ryobi RCS4040 Chainsaw you those to adjust the carb hi is balls out running , sometimes it sounds sick or ...

and there set up when the engine is hot and running,,,first the high rev ste up tweek the screw till the engine is running at full revs then tweek the low revv till the engine will stay ticking over,,

to set you low end.  The high end of course would be set with how high you want the RPM. With this side of it you need to check the manufacturers notes for how high. Too high is bad for the motor

...066 MAGNUM CHAINSAW JUST WONDERING IF YOU CAN TELL ME HOW MANY TURNS THE MIXTURE SCREWS SHOULD BE SET AT one turn high and low 66 has compesator carby willrun rich up high but will lean under ...

Question about Garden

1 Answer

set at high speeds ( H screw ). In the beginning is good put both to set at 1.5 turns from full closure. And then, if the chainsaw starts, you can adjust a carburetor work. Careful with adjusting with

...on a walbro carberator wa19 on the needle on a poulan chainsaw xxv? The chain dies out when it is under cut or high rpms Initial setting is one full turn on low and high side. Fine tune from

...high low settings on a stihl fs55. Weed eater? Which knob is high which is low on fs55 stihl fuel settings there are three holes in side cover one has an l for low one has an h for high and the third ...

Question about McCulloch Garden

2 Answers

set the carb onmcculloch chainsaw troubleshooting 3516 Both the High and low speed jets need to be 1 1/2 turns open. Then fine tune from there. Set the H needle so that (with engine warm) the engine 4

Not finding what you are looking for?
Husqvarna Craftsman 36cc, 16 In. Gas Chain Saw Logo

153 questions posted

Ask a Question

Usually answered in minutes!

Top Husqvarna Garden Experts


Level 3 Expert

85223 Answers


Level 3 Expert

775 Answers

Wayne McNeil

Level 2 Expert

209 Answers

Are you a Husqvarna Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides