Husqvarna Craftsman 36cc, 16 In. Gas Chain Saw "saw shuts" Questions

...saw starts but shuts off when I press the trigger to move chain; Make sure the chain brake is not engaged.Pull it toward the handle until it latches.Also check for sawdust under the chain sprocket ...

what is a muffler safety shut off on a chain saw? Never heard of a "muffler safety shut off". The chain brake handle sits above the muffler, could this be the safety part you are looking for?

Chainsaw will run but will not shut off with the run/stop switch My Chain Saw will run with no problems, but when I try to shut it off, it won't shut down with the Run/Stop switch. I have tried ...

my saw a jonsered 670 champ keeps putting oil out the oiler tube even when the saw is shut off , until the tank is empty any ideas or fixes? Try loosening the oil filler cap when you are finished ...

...saw gets hot there is a ping sound than shuts down When using my chainsaw once it has run for about 8 mins hard sawing there is a ping sound and then the engine quits. After letting it set for about ...

craftsman 42cc chain saw bought this saw in 04 new.been pack up and when you run the saw and it get hot .when you shut saw off and let it sit it will vapor lock.had the saw to too shop and they can ...

want to know what the button on the top right corner of the saw is meant for ,often while cutting my left thumb seems to hit this and shut the saw off. There is a little diagram beside the button by I

...saw will start , but quickly shuts down Like the following link: http://www.fixya.com/support/r3706813-2_cycle_fuel_system_repair Typical 2375 IPL (may not be your saw) ...

Won't start when motor is warm. Saw for half hour and shut it off and it refuses to start again this sure sounds as if it's an overheating problem , this causes the ign ckt to over heat and shut off ...

Poulan Model #2175, type 1: Saw would not crank after about 1 year of sitting up. I replaced fuel line and purge lines. After that saw started after about 6 pulls from cold start. After running for ...