Chainsaw starts but will only stay running if i push the primer bulb before it stalls out pump the primer till it's full of fuel Before you start it Warm the engine--turn the H needle on the ...
...chainsaw There is no fixed carburetor setting on these engines, just two screws to adjust low-end and high-end operation. Special tool may be required, there are about a half-dozen screw head ...
engine stalls after acceleration - Start fine, idles fine, but won't run at full speed. Engine dies when throttle is engaged more than half-way. Fuel filter is ok, air filter has been cleaned. Sounds ...
My Echo CS starts fine but then will not accelerate. Sometimes, after it's warm, it will work OK, but more often, it acts as if the chain lock is engaged and almost wants to stall as the throttle is ...
Saw won't start without starting fluid. Eager ****** 2.1, Power Mac 300 series. Without starting fluid sprayed onto the air filter, saw won't even pop or burp when pulling starter. Once ...
...chainsaw carburetor Find the 2 screws. There will be a (h) high and (L) low. These are for hig rpms and low rpms. First tighten the screws. Then unscrew them about 1-1/4 turns. Then start the saw and ...
engine with some choke. If this helps, try adjusting the carburetor high speed screw. 33 cc ranger1 16 inch bar dies when accelerating , is low speed jet adjustment. recommend adjust both high and low
...chainsaw, but usually there is a boot that surrounds the high and low speed jets. you have to take the cover off the chain saw to get to the boot and pull the boot off the high & low speed jets. ...
153 questions posted
Usually answered in minutes!
529 Questions
514 Questions
473 Questions
353 Questions
122 Questions
