Yamaha 1,000 Watt Portable Generator #EF1000ISC "air cleaner cover removal" Questions

...air cleaner, sprayed starting fluid in the intake area, ran for a few seconds. Removed carb, blew it out with compressed air, same problem -- no change. Next step will to remove carb, soak in carb ...

cleaner for several hours. Blew it out (again) and reinstalled it. Now generator starts on first pull like new! Remove the air filter and squirt a little gas into the carburetor. If it starts and dies

air filter and have carb cleaner ready. If you are near the gen when it begins to quit, spray just a little carb cleaner to see if engine tries to run. If engine begins to run or continues to run with

...cleaner--blow out with compressed air. If the fuel in the bowl smells stale, then remove the float and needle valve. Wash the needle valve seat, but not the needle--just wipe clean. Check that fuel ...

...air cleaner is the choke. The other one is the throttle. Both valves operate through 90 degrees of rotation. The choke should close all of the way with the lever in the start position and be open all ...

...air for carburetor(you can clearly see they are on carb). As stated above there are not many adjustments. There is no choke for the model I have; just an on and off switch and fuel prime button. The ...

...air cleaner. It may just be dirty. Also check the spark plugs, cables, ignition points if it has them. Try running it under load in very dark conditions with any side covers removed so you can watch ...

cleaner, though the correct procedure would be to overhaul the carb itself; choke the throat opening (after removing the air filter and the base plate. Use your palm and cover the throat opening while

...air cleaner element and cover off for now. 9) Put in fresh fuel, open the fuel valve and wait 5 minutes. Look down the carb intake as see if there is fuel pouring out where it shouldn't, if there ...

...air cleaner, make sure the choke is open. Spray a bit of either carb cleaner, ether, or brake cleaner into the intake. Make sure the switch is on and pull the rope, If you've got a bad carb you'll ...