Craftsman 1/2" Impact Wrench "new work" Questions

...you have tried this but use a lubricant on the trigger if that doesnt work try unscrewing the case and inspecting the trigger inside for broken or stuck parts you mayneed to buy a new trigger ...

...work at and also purchased sets of new hammer pins from him also, take note that the round cam that hammer pins ride on will get nicked and damaged and take out new hammer pins so watch out for that ...

...new impact sockets, but can't get a socket onto the gun. Leaned on it with all my weight, wiggled, nothing. and yes they are both 1/2" drive. WTH? I think your meaning that the socket doesnt seem to ...

...new. Used for years in the shop then put it in the bottom of the tool box when the valve went out years ago. In a clean up round I pulled it out to make the decision fix or recycle. One of those not ...

...work the oil deep into the gun. Ley it soak 1 hour, and repeat the process, working the oil in, and the air out. Remove it from the oil, and drain the oil back into the bucket by holding the trigger ...

...get the gun to start. It just puffs air. I'm running 100-120 psi, filter, oiler. I have put in new vanes, have run them dry, wet, very wet, and have tried every combination possible. We even buy ...

work it just blows air. The anvil rounds over, then the pins break. New pins will just keep on breaking without a new anvil. there is a rebuild kit available anywhere they are sold, biggest reason for

...to see if anything is obviously broken, or gummed up. It looked fine. Any advice? Is it time for a new gun? most of the problems accure from being dry try 2 or 3 drops through the air intake fitting ...

...fine last time. after one nail, piston blade (the thing that drives the nail) won't retract--so a new nail can't get loaded. just makes a mark on the wood. if I disconnect and unload it i can push ...