Craftsman 1/2" Impact Wrench "gun blows air" Questions

...blows out a vent at the bottom and the anvil doesn't rotate. If debris enter the gun, over time the vanes will not move into proper positon and react to air-flow. Vanes can become stuck if stored ...

...gun. Ley it soak 1 hour, and repeat the process, working the oil in, and the air out. Remove it from the oil, and drain the oil back into the bucket by holding the trigger down. Hook up the air, and ...

...blows air thru when I pull the trigger, does not turn. Thanks, Doug I have ran into this many times, even though you keep it oiled dirt can and will get inside. what you need to do is unscrew the 4 ...

gun The air motor is probably shot. Turn the socket a few revolutions by hand, and see if it frees up and starts working. A couple of firm raps on the workbench might help. Otherwise take it apart and

...gun doesn't speed up to it's original scream you will have to remove the four 5/32" set screws and see what's worn. To open it hold the impact by the nose 3" off the table and position a ...

blows air The problem stated could be in one of two places. 1st the hammer mechanism, symptom when trying to loosen or tighten a nut the tool locks up. Disassemble and and check components for wear or