DeLonghi DE500 Dehumidifier "corrosion coils" Questions

Ad

coils and spraying a light coat of WD40 on them, may slow the corrosion process. The bottom line is this. Until the manufacturers switch from aluminum coils to copper coils, the problem will always be

Ad

Question about Maytag Dehumidifiers

1 Answer

...coils and contacts will help abate corrosion during the off season. If you are in an area where you use the dehumidifier continuously , then you should step up your routine maintenance to every 6 ...

Ad

Question about Maytag Dehumidifiers

1 Answer

...chrome looking clip that was already there). Problem fixed! Well, almost... I did have to clean the corrosion off my power control board as well, but it survived luckily. After doing this to mine, my ...

Question about Fedders Dehumidifiers

2 Answers

coils are dirty and need to be cleaned. Critical problems: 1 The humidity sensor has failed an needs to be replaced. 2.The compressor is low on refrigerant gas and needs to be recharged. Sometimes the

Question about Fedders Dehumidifiers

2 Answers

...to condensation from the extended freeze-ups. If you're lucky, you might be able to clean off the corrosion and it may still work. To fix the freeze-ups, you can order another front panel control ...

...coils on the evaporator coil.  The evaporator coil is behind air filter cover.  Checked humidistat wire harness connections for corrosion and tested with volt meter 5-8 volts??  Ohmed ...

...coils. 5. Ambient air temperature at floor level is between 40 - 60 degrees. dehumidifiers do not work well between those temperatures (Unless, you have a Low Temp Unit). This applies mainly to where ...

Question about Dehumidifiers

3 Answers

Hi

...coils. Run it to the outside and affix it to the side of the unit using double-sided tape. Then place the cover back on without tightening the screw nearest where the cable is run. In a years time ...

Question about DeLonghi Dehumidifiers

2 Answers

...coils on the evaporator coil.  The evaporator coil is behind air filter cover.  Checked humidistat wire harness connections for corrosion and tested with volt meter 5-8 volts??  Ohmed ...

Question about DeLonghi Dehumidifiers

2 Answers

coils (on 4 pin connector), but no luck. Any other suggestions. I also get E3 error and was told to ship the product to a dealer in CT. It will cost more than the unit is worth to ship and repair this

Not finding what you are looking for?
DeLonghi DE500 Dehumidifier Logo

61 questions posted

Ask a Question

Usually answered in minutes!

Top DeLonghi Dehumidifiers Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a DeLonghi Dehumidifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...