Question about Kenmore Washing Machines
usually its just foam in sensor tube,as prior using too much or wrong type of detergent(for hand wash,or else). Do few cycles with just and only water,or open machine and blow tubes to level "sensor"
machine keeps stopping and showing fo5 ALARM CODES E11 Problems with water fill in wash phase E10 Cycle PAUSED 8.2 E12 Problems with water fill in drying E10 Cycle PAUSED 8.3 E21 Problems with water ...
Question about Zanussi Washing Machines
washing machine keeps stopping mid wash and coming up error (32 motor surrisc) zanussi keeps stopping and reporting E32 as a fault, how do i fix this? Hello ALARM CODES E11 Problems with water fill in
Question about Frigidaire Washing Machines
washer does not spin. It fills up with water then drains it. it skips the washing cycle. Either the selector switch is bad or the water level sensor is bad. You can test both with an ohmmeter.
...washing --- Drain, end of cycle 8.25 E63 Insufficient heating during drying Heating phase skipped 8.26 E64 Overheating during drying --- Heating phase skipped 8.27 E66 Power relay to heating element ...
Question about Whirlpool Washing Machines
...sensor is working as if this is not contacting on reaching the set level the program will not addvace.Please check for tips from this link ...
washing machine went through the wash cycle, then displays F8, it first started with F5 and my hubby found a screw in the pump, great he thought he had fixed it but now it goe's through the wash cycle
...machine. If you turn off the washer and skip ahead to the spin cycle it spins out the clothes and turns off in a normal fashion. Hi Lu here.Did you replace the rps sensor with the same one as you ...
Question about Whirlpool Washing Machines
skips the drain and spin cycles, and no error code flashes? If the same fault comes on other programs then it can be due to the controller board.However you can check the drain filter and pump , check
skips wash and rinse and then drains. after drains error code oL comes up. what is wrong with it. Hi jbrundage1. I believe you have a UL error code on the washer. It means that the sensors
843 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
947 Questions
680 Questions
658 Questions