Question about Nissan Altima
...hydraulic valve lifter problem or if the car has not been properly maintained you could have signs of engine bearing problems. Double-check your Engine oil level immediately. If it is low or not even ...
...hydraulic lifters, but unless you dont change your oil every 5k miles and/or use some cheap oil, there should be no problems. You should have a real mechanic look at it, and verify that you have good ...
...Hydraulic lifters can fail for several reasons: Dirt lodged in the check valve can allow the lifter to leak. Too much wear between the lifter and the body can cause excessive leak-down. This results ...
...hydraulic lifters have no valve lash adjustments if u have a tick do an oil change with a flush possible sludge build up if still noisy and want the get hands a little dirty after 30 pop valve cover ...
Question about Nissan Altima
...hydraulic lifters and no compression! I just replaced all of my hydraulic lifters and no compression. The just whines over quickly. 1992 Chevy van 350 engine 5.7 liter. I adjusted the valves perhaps ...
...hydraulic lifter witch triggered the knock sensor, which is there to detect knocks for oil related problems but unfortunaetly picked up my knocking too and thus went into its "energy saving" mode and ...
...hydraulic lifters. the older cars used to have a fixed valve clearance with tappets, but now they use hydraulic lifters. the problem with these is if you don't change the oil at a regular interval or ...
Question about Cars & Trucks
...hydraulic lifters will maintain a problem regardless if temperature Most likely an injector problem caused by wiring to the injector , or connection at the ECM may be moisture around the plug or in ...
Question about Oldsmobile Cars & Trucks
hydraulic" lifters, and are not adjustable. If you have a lifter that is "clattering" which would make it sound as though it needed adjusting, likely the problem is a hydraulic lifter, or the camshaft
...hydraulic valve lifters. No adjustment is required.Rocker arm bolts (10) to 32 N.m (24 ft. lbs.). The hydraulic lifter should be on base circle of the camshaft. DO NOT OVERTIGHTEN. Hope this
326 questions posted
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,306 Questions
569 Questions
534 Questions
